How to solve the problem of blockage found in use? Many customers think that this is a very complicated problem, but if this blockage problem is not handled properly, it will easily cause damage to the equipment, thereby affecting the efficiency of use. Therefore, everyone should pay special attention to it. You can easily solve the problem by grasping the following points.
1: The hard sediment in the volute of the horizontal slurry pump causes it to be blocked, and measures to remove the sludge can be taken.
2: If the axis of the shaft and the feeding box are different, the main reason is that the machining error is large and the installation is incorrect. Care should be taken to check that the installation is correct after installation. If the sealing water ring is seriously worn, it needs to be replaced with a new water ring. If the sealing water pipe is blocked, the sealing water cannot enter the middle of the packing, which will cause the packing to wear out quickly, resulting in material leakage. The blocked water pipes should be dredged and the sealing water should be kept clean.
3: If the impeller or the water inlet and outlet pipelines are blocked, you can take the cleaning of the impeller or pipeline. If the impeller is seriously worn, it should be replaced. If the packing port leaks, the packing should be pressed tightly. If the conveying height is too high, the loss resistance in the pipe is too large, so reduce the conveying height or reduce the resistance.
The horizontal slurry pump should be regularly maintained during its use, including dredging, so that the problem of clogging of the slurry pump can be effectively avoided. When dealing with such problems, different treatment methods can be selected according to the specific conditions of the blockage.
